PP 3D GF30

Polypropylene with 30% glass fiber content is resistant to concentrated solutions of acids and alkalis.

It is recommended to print on regular polypropylene tape as a table cover (in this case there is no need to heat the printing table), OR heat the table to 60-70C and use a rough coating (the back of a mirror, ceramics, frosted glass, etc.), border in In this case (Brim) will also not hurt when slicing.

Printing options

• Nozzle temperature 235-255°C
• Print bed temperature 0-60°C
• Blowing the model as needed up to 50%
• Printing speed 30-50 mm/s
• Plastic supply (Flow) 100-105%
• Nozzle diameter from 0.4 mm (min)
• Min. layer height 0.15 mm
• Bending temperature under load (1.8 MPa) +145°С
• Charpy impact strength without notch (+23°C) 46 kJ/m2
• Charpy impact strength without notch (-45°C) 20 kJ/m2
• Tolerance on rod diameter 0.03 mm
• Quantity on reel ~ 280 m
• Shrinkage 0.5%
• Hardness Shore A —
• Elongation at break 4%
• Maximum tensile strength 75 MPa
• Density ~1.15 g/cm3